● Designed structure and working principle
One end of the machine is equipped with a motor and a reducer. The motor power is transmitted to the reducer through the belt, and the reducer is transmitted to the V-bucket through the coupling. Continuously operate the V-shaped barrel to drive the material in the barrel to be mixed up, down, left and right in the barrel.
Special designed for Vitamin and Mineral material etc. pre-mixing, powder or granular materials in the chemical, food, pharmaceutical, feed, ceramic, metallurgical and other industries.
Stainless steel material for complete machine or material touched parts
● Low Residue
High polishing processing of the material touched side for minimum residue
Compressed air cleaning device(option)
● Operation And Maintenance
1. Installation: Place the machine stably, install the machine feet, and level it so that the mechanical energy can run freely.
2. Before use, add oil to the oiling station, then carry out no-load operation, check whether the fasteners are loose, whether the electrical is normal, whether the machine is working properly, and if there is any abnormality, carry out renovation and debugging.
3. Turn the feeding port to the top, open the feeding cover for feeding, the feeding amount should not exceed the specified volume, then close the feeding cover and start the machine to run. If abnormality is found on the way, it must be stopped for inspection.
4.the replacement of the variety must be washed inside and outside the hopper.
What about the mixing time?
4-12min according the mixer volume from 0.18-6m3
What about the mixing rotor speed?